VR Nozzle

  1. The power button is located at the back, press it once to power on the nozzle. You can verify its on by checking for a green light around the button.
  2. Twist the head of the nozzle to change the spray jet.
  3. To teleport whilst holding the nozzle press and hold this button. Aim somewhere on the ground and release the button to teleport toward that location.
  4. To spray with the jet of the nozzle pull back this handle.
  5. To go full max with spray, push down this lever whilst pulling back the handle.
  6. Slot the Quest 2 controller so the sensor ring of the Quest 2 controller goes around the front nozzle.

Articles

Powered By EazyDocs