Elementary Quickstart Guide
Introduction
This guide is designed to help you get up and running with ease. Whether you are a first-time user or need a quick refresher, you will find step-by-step instructions and essential tips to start using the product effectively.
In just a few steps, you will be equipped with the knowledge to make the most of your experience.
Let's get started!
1. Handling the controller
How to interact within the ER courses
2. Connecting the system
Attach the power cable to the case
1. Match the Neutrik PowerCON with the Neutrik Inlet on the Case
2. Next, push the Neutrik PowerCON into the case
3. Twist the Neutrik PowerCON until you hear a click sound
Plug the power cable into the outlet
3. Setting up the extinguisher
Connect the controllers with the extinguisher
1. Put the left controller in the controller slot at the end of the extinguisher hose.
2. Put the right controller in the controller slot next to the handle of the extinguisher.
Pull the safety pin and squeeze to spray
4. Starting the application
Tap the Elementary Application found on the middle of the screen. The application is now booting up, which may take up to 2 minutes to complete.
5. Equipping the VR hardware
Powering on the VR headset
Press the power button on the side of the VR headset.
Adjusting the VR headset
Adjust the Elite Strap on the VR headset for a perfect fit.
Adjusting the lens width
Adjust the lenses of the VR headset for a clearer image.
Activating the controllers
Press any button to activate the controllers.
6. Setting up the boundary
Create new boundary
Press Create new boundary to create your training ground.
Set the floor level
Touch the floor to set the floor level, then press Confirm.
Drawing your training ground
Start drawing your space on the ground by using the trigger button on the controller, then press Confirm to create the boundary.